I have a set of Begali Adventure Paddles. They are wonderful paddles. I have the mount for my IC-705, KX2, and desktop. Each mount works well. However, there are times when I do not have a stable platform for my radios or the paddles. At these times I usually hold the paddles in my hands. My go to handheld paddles are my N0SA SOTA paddles. I got mine from his last run. They are an excellent paddle.
I tried holding the Adventure paddles in my hand but I would cause errant dits and dahs. I first thought I would 3D print a box for the paddles--to much thought. I then thought about getting some square aluminum tubing. Too expensive. I scrouged around in my shop and found some 1" angle aluminum. Perfect. Before I go on let me explain, that this was done with hand tools. A hacksaw, files, hand drill and drill bits. I also used a Dremel tool a little. This project is far from perfect. I never let perfection be the enemy of good enough.
Here is the piece roughed out.
The slot is where the finger guard mounts to the bottom of the paddler using a 4-40 screw. Mounted it looks something like this.
The guard extends past the end of the paddles to help protect the cable where it enters the paddle.
In use the paddle/guard combo looks like this.The guard keeps my index finger from touching the paddle lever and allows me to put my thumb below the paddle lever on the other side. It is very comfortable to use even with my large mitts.
A coat of primer, followed by paint and a clear coat and viola!, it is finished.
I will let it cure overnight and it will be ready for the next adventure. 73-de Scott
No comments:
Post a Comment